Method For Checking The Front Axle Oil Level - Komatsu PW118MR-11 Operation & Maintenance Manual

MAINTENANCE
1.
Set the machine to the greasing posture shown on the fig-
ure, lower the work equipment to the ground,and stop the
engine.
2.
By using a grease pump, pump in grease through the grease fitting shown by arrow.
(1) Outrigger cylinder base pin (2 point)
(2) Outrigger arm pivot pin (2 points)
(3) Outrigger cylinder head pin (2 point)
(4) Brackets pivot pin (2 points)
(5) Bucket cylinder base pin (2 points)
(6) Ties pivot pin (2 points)
(7) Blade arm pivot pin (2 points)
(8) Blade cylinder head pin (2 points)
(9) Ties - blade connection pin (2 points)
(10) Arm - blade connection pin (2 points)
3.
After greasing, wipe off any old grease that is pushed out.

METHOD FOR CHECKING THE FRONT AXLE OIL LEVEL

Immediately after the engine is stopped, its parts and oil are still very hot and may cause burn injury.
Consequently, wait until they have cooled down before starting the work.
For the control, position the machine on solid and flat ground, place the equipment on the ground and stop the
engine.
k k
WARNING
WENAM00130
MAINTENANCE PROCEDURE
4-41