OPERATION
CIGARETTE LIGHTER
The cigarette lighter is used to light cigarettes.
When the cigarette lighter is pushed in, it will return to its origi-
nal position after several seconds, so pull it out to use it.
If the cigarette lighter is removed, the socket can be used as an
85 W (24 V x 3.5 A) power source.
NOTICE
This cigarette lighter is for 24 V. Do not use as a power
supply for 12 V equipment.
ATTACHMENT 2 PROPORTIONAL SWITCH
The 2nd-line attachment proportional switch is on the left PPC
valve lever and it is used to operate the attachment.
For handling of the 2nd-line attachment proportional switch,
see "ATTACHMENT 2 PROPORTIONAL SWITCH (6-10)".
1st LINE ATTACHMENT PROPORTIONAL / BREAKER ACTIVATION SWITCH
The 1st line attachment proportional / breaker activation switch is positioned on the right joystick and is used
with the attachment or when operating mode B (Breaker) is selected to actuate the breaker.
To use the 1st line attachment proportional / breaker activation
switch, see "1st LINE ATTACHMENT PROPORTIONAL /
BREAKER ACTIVATION SWITCH (6-10)".
BLADE/OUTRIGGERS CONTROL SWITCH
The switch is located on the right hand joystick and is used to
switch the boom controls to the blade/outrigger controls.
When the blade/outrigger mode is activated, the icon (a) is dis-
played on the machine monitor for 2 seconds and the selected
blade/outrigger can be controlled, the signal lamp (b) of which
turns green. For information on the selection of the blade/
outriggers, see "BLADE/OUTRIGGERS SELECTOR SWITCH
(3-62)".
WENAM00130
EXPLANATION OF COMPONENTS
RKA48510
RKA48500
RKA61560
3-103