Method For Checking After Finishing Work; Lock - Komatsu PW118MR-11 Operation & Maintenance Manual

MACHINE OPERATIONS AND CONTROLS
4.
Insert the boom swing safety device (3).
5.
Set the controls locking lever (4) to the LOCK position (L).
6.
Check the engine coolant temperature and engine oil pres-
sure with the machine monitor.
• If the engine coolant temperature gauge is in the red
range, cool down the coolant until the gauge enters
the green range, and stop the engine. Inspect and
take the necessary remedies.
• If the engine oil pressure caution lamp is lit, stop the
engine immediately. Inspect and take the necessary
remedies.
7.
Turn the ignition key to the OFF position (A).
Remove the ignition key, close the doors and windows and
leaving the key at a preset location.

METHOD FOR CHECKING AFTER FINISHING WORK

Perform it after stopping the engine.
1.
Walk around the machine and check the work equipment, machine exterior, and undercarriage, also check
for any leakage of oil or coolant. If any problems are found, repair them.
2.
Fill the fuel tank.
3.
Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
4.
Remove any mud affixed to the undercarriage.

LOCK

Lock position
Always block the following elements:
3-214
WENAM00130
OPERATION
RKA61850