10Gbase-Lrm Xfp Specifications - Avaya Ethernet Switch 5000 Series Manual

XFP specifications
Maximum average receive power for
damage
Maximum receiver sensitivity in OMA
Maximum receiver reflectance
Stressed receiver sensitivity in OMA
Receiver electrical 3 dB upper cutoff
frequency
The stressed sensitivity values are for system level BER measurements, which include the
effects of clock and data recovery (CDR) circuits. Avaya recommends that you allocate at least
0.4 dB additional margin if you make component level measurements without the effect of CDR
circuits.

10GBASE-LRM XFP specifications

The 10GBASE-LRM XFP provides 10 GbE service at a wavelength of 1310 nm. This XFP can
attain a reach of up to 220 m on 62.5 μm multimode fiber. This XFP provides built-in electronic
dispersion compensation.
The following table lists the transmitter and receiver specifications for the 10GBASE-LRM XFP.
These parameters meet the IEEE 802.3aq-2006 standard. The part number of this XFP is
AA1403007-E6.
In this table, the OMA, average launch power, and peak power specifications apply at TP2,
after patch cord loss is accounted for.
Table 26: IEEE 802.3aq 10GBASE-LRM XFP specifications
Data rate
Line rate (64B/66B code)
Center wavelength range
Distance
Link optical power budget
Maximum transmitter waveform and
dispersion penalty (TWDP)
58 Installing Transceivers and Optical Components on Avaya Ethernet Switch 5000 Series
Parameter
Parameter
Comments? infodev@avaya.com
Specifications
0 dBm
– 11.1 dBm
– 12 dB
– 7.5 dBm
12.3 gigaHertz (GHz)
Specifications
10.0 Gb/s
10.3125 Gb/s ± 100 ppm
1260 to 1355 nm; 1310 nm nominal
Up to 220 m, for more information, see
27: 10GBASE-LRM channel insertion loss
and range on page 59
1.7 to 1.9 dB, for more information, see
27: 10GBASE-LRM channel insertion loss
and range on page 59
4.7 dB
Table
Table
December 2013