Removing An Sfp - Avaya Ethernet Switch 5000 Series Manual

Small form factor pluggable transceivers
The following figures shows a typical mechanisms used on SFP transceivers; other locking
and extractor mechanisms exist, although they are not shown here. In the following figure, the
SFP still has the bore plug installed. Pull the bail to release the device.
The following figure shows the 1000BASE-SX MT-RJ SFP. Push the tab to release the
device.
The following figure shows the wrap-around latch-type extraction mechanism. To remove the
device, push the collar towards the module.

Removing an SFP

Remove an SFP to replace it or to commission it elsewhere.
26 Installing Transceivers and Optical Components on Avaya Ethernet Switch 5000 Series
Comments? infodev@avaya.com
December 2013