To prevent damage from electrostatic discharge, always wear an antistatic wrist strap
connected to an ESD jack.
Procedure steps
1. Disconnect the network fiber cable from the XFP connector.
2. Affix a dust cover over the optical connector.
3. Pull the bail mechanism on the XFP to release the XFP.
4. Slide the XFP out of the module XFP slot.
5. Replace the port dust cover or EMI plug in the module.
6. Store the XFP in a safe place until needed.
Installing Transceivers and Optical Components on Avaya Ethernet Switch 5000 Series
If the XFP does not slide easily from the module slot, use a gentle side-to-side
rocking motion while firmly pulling the XFP from the slot.
Important:
If you discard the XFP, be sure to dispose of it according to all national laws and
regulations.
Removing an XFP
December 2013
53