Job Aid - Avaya Ethernet Switch 5000 Series Manual

Important:
The attainable cable length can vary depending on the quality of the fiber optic cable
used.
Model and connector
1000BASE-SX (LC)
1000BASE-SX (MT-RJ)
1000BASE-LX (LC)
1000BASE-XD CWDM (LC)
1000BASE-ZX CWDM (LC)
100BASE-FX (LC)
NOTE: Only the 5600 Series
switches support this SFP.
T1 (RJ-48C)
For more information about specifications for these SFPs, see
page 29.

Job aid

You can use a Digital Diagnostic Indicating (DDI) SFP in an Ethernet Routing Switch module
that supports SFPs. The switch supports the optical functions of the SFP. A future release will
provide access to the DDI information.
The SFPs described in this section are all RoHS -E6 compliant.
The following table lists and describes the Avaya SFP models with DDI capability. All these
SFPs use LC connectors.
1000BASE-T (RJ-45)
1000BASE-SX
1000BASE-LX
1000BASE-XD
Installing Transceivers and Optical Components on Avaya Ethernet Switch 5000 Series
AA1419013-E5
AA1419014-E5
AA1419015-E5
AA1419025-E5 to
AA1419032-E5
AA1419033-E5 to
AA1419040-E5
AA1419074-E6
AA1419075-E6
Model
AA1419043-E6
AA1419048-E6
AA1419049-E6
AA1419050-E6
Product number
Product number
Selecting an SFP
Description
850 (nm), up to 275 or 550 m
850 nm, up to 275 or 550 m
1310 nm, up to 10 km
1470 nm to 1610 nm, up to 40
km
1470 nm to 1610 nm, up to 70
km
1310 nanometers (nm), up to
2 km
1.544 Mb/s Ethernet to T1
remote bridge.
SFP specifications
Description
CAT5 UTP, up to 100 m.
Because the 1000BASE-T
device is all electrical, there
is no need for DDI support.
850 nm, up to 275 or 550 m
1310 nm, up to 10 km
1310 nm, up to 40 km
December 2013
on
23