Initial Value Change List - Mitsubishi F700 Series Instruction Manual

4.28 Initial value change list

Displays and sets the parameters changed from the initial value.
Operation
1. Screen at powering ON
The monitor display appears.
2.
Press to choose the PU operation mode.
3.
Press to choose the parameter setting
mode.
4.
Turn until
5.
Pressing changes to the initial value
change list screen.
6.
Turning displays the parameter number
changed.
Press to read the currently set value.
Turn and press
setting
(refer to step 6 and 7 on page 55)
Turn to read another parameter.
The display returns to
parameters are displayed.
7.
Pressing in
the parameter setting mode.
 Turning
 Pressing
REMARKS
 Calibration parameters (C0 (Pr. 900) to C7 (Pr. 905), C42 (Pr. 934) to C45 (Pr. 935)) are not displayed even they are changed from
the initial settings.
 Only simple mode parameter is displayed when simple mode is set (Pr. 160 = 9999 (initial value))
 Only user group is displayed when user group is set (Pr. 160 = "1").
 Pr. 160 is displayed independently of whether the setting value is changed or not.
Parameters referred to 
Pr. 160 User group read selection
C0 (Pr. 900) CA terminal calibration
C2 (Pr. 902) to C7 (Pr. 905) (Frequency setting bias/gain parameter)
C42 (Pr. 934) to C45 (Pr. 935) (PID control)
appears.
to change the
Flicker
after all
status returns to
sets other parameters.
displays the change list again.
Refer to page 185
Refer to page 144
Refer to page 256
Display
PU indication is lit.
PU EXT NET
PRM indication is lit.
(The parameter number read previously appears.)
Frequency setting complete!!
···
Refer to page 172
Initial value change list
323
4 4