How To Calibrate The Terminal Ca When Using The Operation Panel (Fr-Du07) - Mitsubishi F700 Series Instruction Manual

Monitor display and monitor output signal

4.11.5 How to calibrate the terminal CA when using the operation panel (FR-DU07)

Operation
1.
Confirmation of the RUN indication and
operation mode indication
2.
Press to choose the parameter
setting mode.
3.
4.
Press to read the present set value.
" " (initial value) appears.
5.
Turn to change it
to the setting value of "
6.
Press to set.
7.
Turn until
8.
Press to display
9.
Set to C0 CA terminal calibration.
10.
Press to enable setting.
11.
If the inverter is at a stop, (press
or ) to start the inverter.
(Motor needs not be connected.)
12.
Turn to adjust the indicator needle
to the desired position.
13.
Press . Setting is complete.
REMARKS
 Calibration can also be made for external operation. Set the frequency in External operation mode, and make calibration in
the above procedure.
 Calibration is available even during operation.
 For the operating procedure using the parameter unit (FR-PU04/FR-PU07), refer to the parameter unit instruction manual.
Parameters referred to 
C0 CA terminal calibration
C1 AM terminal calibration
146
".
Flicker...Parameter setting complete!!
appears.
.
Flicker...Parameter setting complete!!
By turning , you can read another parameter.
Press to return to the
Press twice to show the next parameter (
Refer to page 144
Refer to page 144
Display
(When Pr. 54 =1)
The parameter
number read
previously appears.
C0 to C11
setting
is enabled.
The monitor set to Pr. 54 CA terminal
function selection is displayed.
+
Analog indicator
-
indication (step 8).
).