York YK-EP B Operation & Maintenance Manual page 24

SECTION 2 - OPTIVIEW CONTROL CENTER INTRODUCTION
NAVIGATION
System
Used to provide additional system information.
Evaporator
A detailed view of all evaporator parameters, including
the programmable Leaving Chilled Liquid Setpoints.
Condenser
A detailed view of all condenser parameters, including
control of the liquid level functions.
Compressor
A detailed view of all the compressor parameters. This
includes Pre-Rotation Vane control, Hot Gas Bypass
Control, Proximity Probe Calibration, and PRV Calibra-
tion.
Oil Sump
A detailed view of all the oil pump and oil sump pa-
rameters. This includes the Variable Speed Oil Pump
when installed. It also controls the Seal Lubrication
functionality.
24
Motor
A detailed view of the motor controller parameters,
specific to the controller type presently utilized on the
chiller system. This allows programming of the current
limit and the pulldown demand limit values. For a VSD
system, the Adaptive Capacity Control and Harmonic
Filter information is controlled under this screen.
Setpoints
This screen provides a single location to program the
most common system setpoints. It is also the gateway
to many of the general system setup parameters such as
Date/Time, Display Units, Scheduling, Printer Setup,
etc.
History
This screen provides access to a snapshot of system
data at each of the last 10 shutdown conditions.
FORM 160.87-OM1
ISSUE DATE: 8/24/2018
LD22044
JOHNSON CONTROLS