Bailey ADVANCE 2019 Owner's Manual page 33

vehicle about 10 metres to allow the sealant to
be distributed inside the tyre. Stop the vehicle
in a safe place and repeat the above procedure
until the tyre reaches the correct pressure.
If, after 10 more minutes of compressor use,
the pressure gauge (4) continues to give a
pressure reading of less than 3 bar / 43 psi, the
tyre is too damaged to repair. Disconnect the
kit and return it to its compartment, then call
for roadside assistance.
If the tyre has reached the required pressure,
then you may continue driving. Do not exceed
80 KM/H. Do not accelerate or brake suddenly.
After driving for about 8 KM / 5 miles, park the
vehicle in safe place that you can easily access,
and engage the handbrake.
Take out the kit, make sure than the on-off
button (3) is set to off, and insert the electrical
connector (11) into the 12V power socket in the
vehicle. Remove the cap from the repaired
tyre valve, take out the black inflation tube (9)
and connect then firmly tighten it to the valve.
Check the pressure gauge (4) for the correct
tyre pressure reading.
If the pressure gauge gives a reading of
less than 3 bar / 43 psi, The tyre is too
damaged to repair. Disconnect the return it
to its compartment, then call for roadside
assistance. If the pressure reading is 3 bar /
43 psi or above, turn the function select dial
(2) to the right (pump icon), switch on the
compressor and inflate the tyre to the required
pressure. Disconnect the kit and return it to
its compartment. Drive carefully and take the
vehicle to a specialist or the manufacturer's
assistance service as soon as possible.
RESTORING PRESSURE:
Turn the function select dial (2) to the right
(pump icon). Take out the black inflation tube
(9) and connect it then firmly tighten it to
the tyre valve. To adjust any excess pressure
in the tyre press the air release button (5). In
the same way, using the accessories (12), it is
possible to inflate balls and bicycle tyres. The
kit must be used by adults and cannot be left
to minors to use.
CARTRIDGE REPLACEMENT:
Only use Fix and Go cartridges, which can be
purchased from the manufacturer's assistance
service. To remove the cartridge (7), take out
the transparent sealant tube (8), press the
release button (10) and lift out the cartridge
(7). Insert the new cartridge, pressing it firmly
downwards, and wind the transparent tube into
the compressor compartment.
Please observe the fix and go speed limits
29