Bailey ADVANCE 2019 Owner's Manual page 20

16
To prevent the possibility of contaminating the
sensor in your detector and thus affecting its
reliability:
• Never use cleaning solutions on your
detector. Simply wipe with a damp cloth.
• Do not paint the detector.
• Do not spray aerosols on or near to the
detector.
• Do not use any solvent-based products near
to the detector.
Failure of any test should be reported
to the manufacturer's technical
support line 0800 1412561
Do not attempt to repair your CO detector.
Do not remove any screws or open the main
casing of your detector. Any attempt to do so
may cause malfunction and will invalidate the
warranty.
Never ignore any alarm.
w
hat to do in the event of an alarm
• Keep calm and open all the doors and
windows to ventilate your motorhome.
• Stop using all fuel burning appliances and
ensure where possible they are turned off.
• Evacuate the motorhome leaving doors and
windows open.
• Do not re-enter the motorhome until the
alarm has stopped.
• Get medical help for anyone suffering the
effects of CO poisoning and advise that CO
poisoning is suspected.
• Close the windows and doors and do not
use the motorhome again until you have
had a full service of all appliances by
your supplying retailer. In the case of gas
appliances they must be tested by a GAS
SAFE registered installer. Please contact
your Bailey retailer for more details.
• The electro-chemical sensors used in the
carbon monoxide alarm have a limited
lifespan – therefore it is recommended that
a CO alarm is replaced every 5 – 7 years
after manufacture or in accordance with
the unit's instructions. Be sure check the
manufacturing date on the alarms label.