Mode Description - Bailey ADVANCE 2019 Owner's Manual

90
m d
ode eScription
Icon
Water Level
Waste Level
Fill Internal
Tank
External
Temperature
Internal
Temperature
Select
Battery
Leisure
Battery
Amps
Leisure &
Vehicle
Battery
Voltage
User
Settings
Mode
The level in the fresh water tank is displayed as a % on the screen.
The level in the waste water tank is displayed as a % on the screen.
With the external pump connected to the inlet and to an external
water source, press to fill the internal tank.
Note: When the internal tank is full, the pump will stop automatically.
The outside temperature, as detected by a sensor underneath the
motorhome, is displayed on this screen. You can change between
degrees Celsius and degrees Fahrenheit by pressing ENTER and
selecting UP for °C or DOWN for °F.
The inside temperature, as detected by a sensor inside the control
panel, is displayed on this screen. You can change between °C and
degrees °F by pressing ENTER and selecting the UP button for °C or
DOWN for °F.
With 230V mains disconnected, the user can choose to draw power
from the leisure battery OR the vehicle battery. Press ENTER to swap
between batteries. If the "Auto-Battery" feature is enabled (see "User
Settings" section) the system will automatically switch to "Vehicle
Battery" if the "Leisure Battery Voltage" is low (less than 11V). When
230V mains is connected "Leisure Battery" is automatically selected
and cannot be changed.
This screen shows the current being drawn from your leisure battery,
in amps, which is displayed on this screen. A higher current will drain
your battery faster.
This screen shows the voltage of the selected battery as set on the
"Select Battery" screen. If a 230V mains supply is connected then
the charging voltage of the leisure battery will be displayed. An
estimate of your batteries' remaining charge can be seen by pressing
ENTER then the DOWN button. 12V or less reads 0%, and 12.7V or
more reads 100%. You can return to display the voltage by pressing
ENTER then the UP button. To increase accuracy of the battery
voltage reading, switch the "Master Switch" off.
Press the UP or DOWN button to access the User Settings screen.
Description