Advance Water System; Filling Fresh Water Tank; Pressure Switch - Bailey ADVANCE 2019 Owner's Manual

a /a W
dvance llIance ater
Submersible Water Pump (within tank)
Advance/Alliance Models have an on-board
fresh water tank located either underneath the
bed or within a bunk dependant on the model.
The waste water tank is installed underneath
the floor between the chassis members.
The Advance/Alliance range uses a Whale
submersible pump found within the on-board
fresh water tank to pump water around the
motorhome.
The pump is already fully installed and will run
when the pump is turned on via the control
panel. Water will flow when a tap within the
motorhome is opened.
The pump should be inspected and cleaned at
frequent intervals. Ensure the water supply is
free of debris; this will reduce the likelihood of
the pump clogging.
These pumps are sealed units so no further
maintenance is required.
Winterising: To protect against
damage as a result of freezing, drain
the entire water system when not in
use.
S
yStem
f W f W
IllIng Ith reSh ater
To fill the onboard fresh water tank connect a
standard water hose to an external tap, then
feed the other end into the fresh water filler
(shown above).
Monitor the water level inside the tank from
the control panel.
p S
reSSure WItch
Your pressure switch is factory set and should
not normally require adjustment. However,
adjustment may be required if the power
supply voltage has varied from the previous
setting, either due to battery drainage or
higher voltage being supplied when the battery
charger is operating. In the event that your
pump doesn't switch off when you close the
taps or it pulses on and off rapidly when the
taps are fully open, follow these guidelines to
re-adjust the pressure switch setting.
39