External Interface - Fujitsu GP 7000F Manual

CHAPTER 1 Product Outline
CAUTION
IMPORTANT
Under the MANUAL and AUTO state, keyboard STOP+A command and terminal break command will
abort booting-up the system or halt the system while operating system is running. To prevent system
down by unexpected break or STOP+A command, set MODE switch SECURE state.

1.3 External Interface

Various interfaces are available for peripherals and network connections.
PCI Interface
Connector
8
Be sure to install software packages in the "Basic Software Extension" or
"Enhanced Support Facility". Otherwise, above switch functions or proper
messages on LCD panel are not guaranteed.
The GP7000F provides the PCI bus as the I/O interface. The PCI interface has the following
characteristics:
 PCI Local Bus Specification, Rev 2.1 compliant.
 64-bit bus widths, 33 MHz (5.0V) and 33/66 MHz (3.3V).
 Short and long size card can be installed into any of the PCI slots. (*1)
 Data paths are protected by parity.
*1)
The maximum length of the cards that can be installed in PCI slots #8 to #12 of the
M600R Main cabinet is 19.4cm.
The following connectors are installed on the back of the GP7000F main cabinet: