Fujitsu GP 7000F Manual page 198

CHAPTER 14 Troubleshooting
Other Error Messages
164
An abnormality of the system monitoring feature itself as well as abnormality of main cabinet are
indicated by error messages on the LCD panel.
Table 14.7
Message level Message content
(1st line) (2nd line)
SCF: idling... nnn min, POWER
RCI Mainte Mode
I/O Power on
SCF: warning Please Levelup
SCF: alarm RCI Timeout
FMEM Protected
Syshalt nnnnnnnn
SCF: stop BUSerr nnnnnnnn
Error Message
SCF Watchdog
Other Error Messages
Description
nnn minutes passed after the power was turned on
after restoring the power.
RCI mode has changed for maintenance
The power-on sequence for peripheral units is
continuing.
Firmware upgrade processing is incomplete.
Re-executing upgrade processing is required.
Communication processor time-out detected.
Flush Memory is write-protected
Halt on main cabinet detected.
Halt due to bus error. Automatically reset. If the
message is still displayed, however, the system
monitoring feature is down.
Abnormality is detected within the system monitoring
mechanism. If the message is still displayed,
however, the system monitoring feature is down and
power-on is disabled.
Hang-up due to watchdog detection. Automatically
reset. If the message is still displayed, however,
the system monitoring feature is down.