Fujitsu GP 7000F Manual page 21

Task
System Installation
Disk Expansion Unit
Installation
Disk Expansion Unit
Installation
Normal Operation
Normal Operation
Replacing Disk Drives
Formatting Disk Drives
Handling Floppy Disks
Ejecting DAT cartridge
Handling DAT cartridge
Storing 8-mm cartridge
Ejecting QIC cartridge
Storing QIC cartridge
Warning
Install "Basic Software Extension" or "Enhanced Support
Facility"before operating the system. Without this package,
incorrect front panel operations and hardware errors may cause
the system to shutdown or destroy data.
Be sure to replace the power supply fan when installing the
Disk Expansion Unit. Otherwise, the system will shutdown or
disk units will deteriorate due to a temperature rise in the
M200 main cabinet caused by insufficient cooling.
If the installing location (slot) is not set or set
incorrectly, the disk drive may not be hot-swappable.
Data may be destroyed as a result of inadvertently replacing
the different disk drive. Be sure to set the installing
location (slot) correctly.
Also, while replacing or initializing NVRAM, set the
installing location again.
Do not set the AC main line switch to OFF, not disconnect
the power cable or RCI cable while the GP7000F main cabinet
is powered on, unless absolutely necessary. Otherwise, the
data may be destroyed in the disk units.
Do not set the AC main line switch to OFF, nor disconnect
the power cable or RCI cable while the GP7000F main cabinet
is powered on, unless absolutely necessary. Otherwise, the
data in the disk units may be destroyed.
When replacing the disk unit,take the following precautions.
If these precautions are not observed, the disk unit or its
data may be destroyed.
Carefully proceed formatting a disk drive. Once formatting
a disk drive, data on the disk never restored, if you don't
have backup files.
Do not eject a floppy disk while the access LED is on, other
wise the floppy disk or the data on the diskette may be
destroyed.
For information on the handling method, see Table 11.2,
"Handling floppy disks."
Data destruction: Do not press the eject switch during an
operation (when the tape LED is blinking). If the eject
switch is held down for about 5 seconds or pressed 3 times
within a 5 minutes period, the forced ejection function may
execute and the data being written may be destroyed.
When using the data cartridge (DAT), take the following
precautions. If these precautions are not observed, the
DAT unit or its data may be destroyed.
When using or storing the data cartridge, take the following
precautions. If these precautions are not taken, the data
on 8-mm tape may be destroyed.
Data destruction: Do not press the eject switch during an
operation. The forced ejection function may operate and
data being written may be destroyed.
When using or storing the data cartridge, take the following
precautions. If these precautions are not taken, the QIC
tape unit or its data may be destroyed.
ix