Table 11.3 Led Displays On The Dat Unit; Table 11.4 Dat Cartridge Capacity - Fujitsu GP 7000F Manual

LED status display
Active
(green)
Off
On
Blinking
(slow)
Blinking
(fast)
Any status
*1
Tape cartridge information
This tape drive supports 60 m, 90 m, 120 m or 125 m DDS cartridges as shown in Table 11.4 .
Format
DDS-1
DDS-1
DDS-2
DDS-3
Note:
When specifying the data format to be used (native or compressed) for your DAT unit, use the
following device codes:
native
compress /dev/emt/xc[n]
Where x refers to the number specific to your system. To get this number, look in the /dev/rmt
directory to find the entry that corresponds to the SCSI ID 5.
[n] is an optional parameter specifying no rewind.
Table 11.3 LED Displays on The DAT Unit
Attention
(Amber)
Off No data cartridge is loaded.
A data cartridge is loaded.
Loading or unloading a tape, or the tape
unit is being self-diagnosed.
Operating (reading or writing)
On The tape unit has failed.
Blinking Errors have occurred in the data cartridge
on operation. Use a cleaning cartridge to
(slow)
clean the magnetic head. (*1)
If the Attention LED is still blinking after cleaning the head, repeat the operation with
a different tape. If this clears the signal, the first tape is nearing the end of its life.
Blinking of the Attention LED is cleared when a new tape is loaded or when the drive
is power-cycled.
Table 11.4 DAT Cartridge Capacity
Length Native capacity
60 m 1.3 Gbytes
90 m 2.0 Gbytes
120 m 4.0 Gbytes
125 m 12.0 Gbytes
The compressed capacity is assuming a data compression ratio of 2:1.
/dev/rmt/xl[n]
Indication
Compressed capacity
2.6 Gbytes
4.0 Gbytes
8.0 Gbytes
24.0 Gbytes
11.5 DAT Unit
131