Chicco OASYS 2/3 Instructions For Use Manual page 33

"ADJUSTING THE HEIGHT OF THE BACK-
REST")
4. Check the backrest width (see paragraph
"ADJUSTING THE WIDTH OF THE BACK-
REST")
5. Thread the diagonal car seat belt through
the diagonal belt guide (B). Check that the
belt guide (l) open/close button is fi rmly
closed; you must be able to see the white
reference line (Diag. 8).
6. Connect the car safety belt by threading
the lap belt trough the red lap belt guides
(F) under the two armrests in line, and by
threading the diagonal belt under the arm-
rest on the side of the fastener buckle (Diag.
9).
7. Pull the diagonal car safety belt upwards, to
ensure the belt is taut and fi tting properly
over the child's legs and chest; don't tighten
it too much!. (Diag. 10)
WARNING! Check that the car safety belt is
tight enough.
WARNING! Check that the car safety belt is
not twisted (Diag. 11).
WARNING! Check that the diagonal safety
belt fi ts correctly across the child's shoulder
(Diag. 10) and does not press on the neck; ad-
just the backrest accordingly (see paragraph
"ADJUSTING THE HEIGHT OF THE BACK-
REST").
WARNING! Check that the car safety belt ad-
juster is behind the backrest of the car seat (or
at least aligned to it) (Diag. 5).
WARNING! Do not fi t the car safety belt in
any way other than that indicated in these in-
structions! (Diag. 12)
WARNING! Check that the child is strapped
into the child car seat correctly so that he can-
not slide forwards.
Installing the child seat inside the vehicle
without the child inside
When the child is not travelling in the car, the
child car seat should be left secured by the ve-
hicle three-point safety belt, or stowed away
in the car boot. An unsecured child car seat
may be a source of danger for the other pas-
sengers in the event of an accident or sudden
braking.
How to remove the child from the child car
seat
Release the car belt buckle, accompanying the
belt as it retracts.
Removal of the child car seat
WARNING! Remove the child from the child
car seat before removing it.
1. Release the car safety belt.
2. Unthread the diagonal strap through the
guide, accompanying it as it retracts.
Installing and removing the cup holder
The child car seat has 2 inserts, one on the
right and one on the left of the side of the seat
where you can fi t the cup holder whenever
you like.
To install the cup holder:
1. Insert the cup holder into the relative guide
(Diag. 13)
2. Press the cup holder downwards until it
clicks into place (Diag. 14).
WARNING! Do not place glass containers or
hot liquids on the cup holder as they could
harm the child.
To remove it:
1. Press the lever on the back of the cup holder
and lift it upwards, out of the guide (Diag.
15)
The cup holder guides are fi tted with a special
device that makes sure it always remains in a
horizontal position.
To rotate and position the cup holder:
1. Press the lever on the back and rotate it to
the desired position
Adjusting the height of the back rest
The height of the headrest can be adjusted to
10 different positions to adapt the child car
seat to the height of the child.
Make sure the child's head is always well pro-
tected and the car diagonal safety belt is posi-
tioned properly on his shoulder.
When adjusting the height of the backrest,
33