Table of Contents
Advertisement
MAINTENANCE - FILTER SYSTEM (continued)
FILTERING OIL
CAUTION
BURN HAZARD
Protective clothing and gloves
must be worn during the filtering
process
CAUTION
BURN HAZARD
Filter reservoir may be hot.
Wear insulated gloves, or
allow reservoir to cool, before
touching it.
IMPORTANT:
Filtering cooking oil helps to
ensure the quality of the food
product. Careful observation
of the finished food product will
help you determine the optimal
filtering frequency. (Example:
Filter the oil after each six loads
of fresh breaded chicken)
FILTER POWDER absorbs
acids and many other
contaminants in the cooking
oil, allowing the oil to be
used longer before it must be
replaced. Wells Flavor Saver
Oil Filter Powder is available
from your Wells Equipment
Dealer or Authorized Service
Agent.
WARNING:
BE ABSOLUTELY CERTAIN THAT NO WATER REMAINS
IN RESERVOIR OR SUCTION TUBE
WATER WILL BOIL VIOLENTLY IN CONTACT WITH HOT OIL
Boiling water can splatter hot oil and may cause serious injury
NOTE:
Oil should be at least 300ºF (149ºC) DO NOT attempt to filter cold
oil. DO NOT attempt to pump oil when less than 300ºF. Cold oil will
not pass through the filter paper. Filtering cold oil will result in the
premature failure of the filter pump. Damage as a result of pumping
cold oil IS NOT COVERED BY WARRANTY.
NOTE:
DO NOT store oil in the reservoir for any extended period, including
overnight.
IMPORTANT:
The filtration system in your Wells Fryer is designed to filter hot
liquid shortening ONLY. Water, cleaning agents or other liquids will
damage the filter pump and may contaminate the food product
Press POWER SWITCH (item 1) to FILTER. Pump motor will be
energized and heating elements are de-energized.
Remove and examine filter reservoir:
•
Verify that filter leaf is clean and properly installed.
•
Verify that suction tuibe o-ring is in place and in good condition.
•
Make absolutely certain that no water remains in bottom of
reservoir or in suction tube.
Reinstall reservoir, making sure the SUCTION TUBE is firmly seated
in the SUCTION RECEPTACLE.
Press FILTER PUMP SWITCH (item 8) to ON to start filter pump.
Slowly rotate DRAIN VALVE LEVER (item 11) to the vertical position.
Oil will drain from the frypot and into the reservoir. Filter pump will
draw oil through the filter leaf and return it to the frypot.
21
BURN HAZARD
IL2572
Advertisement
Table of Contents
