Table of Contents
Advertisement
PREPARATION PRIOR TO OPERATION (continued)
FOR FRYERS WITH VENT HOOD (WVAE-55.....)
For Ventilator Hood models (i.e. WVAE-55 FC), install DRIP PAN
into mounting bracket behind fryer door at lower right front of fryer.
Close DRAIN VALVE LEVER (item 11) by turning the lever up to the
horizontal (CLOSED) position.
IMPORTANT: Remember to fill the fryer to the COLD OIL LINE with
fresh shortening prior to turning the POWER SWITCH to the FRYER
position. Energizing the fryer without oil covering the elements will
cause serious damage. Damage caused by operating the fryer
without oil covering the elements is not covered by warranty.
Fill FRYPOT to the COLD OIL LINE in the FRYPOT with room
temperature commercial-quality LIQUID SHORTENING. This
requires 55lbs. of liquid shortening.
11
CLOSED
OPEN
IL2564
WARNING:
DO NOT OPERATE UNLESS DRIP PAN IS INSTALLED.
Oil will drip on the floor and slips/falls will result.
Death or serious injury may result from slipping and falling in spilled oil.
WARNING:
CLOSE DRAIN VALVE BEFORE FILLING WITH OIL
Unless drain valve is closed, oil poured into kettle will drain into
reservoir or onto the floor. Oil spill may occur.
Death or serious injury may result from slipping and falling in spilled oil.
FILL TO THIS LINE WITH
ROOM TEMPERATURE
LIQUID SHORTENING
COLD OIL LINE
COLD OIL LINE
SLIP/FALL HAZARD
SLIP/FALL HAZARD
IMPORTANT:
The unit is not equipped with a
SOLID SHORTENING MELT
OPTION, this fryer is designed
for LIQUID SHORTENING
ONLY.
DO NOT USE SOLID
SHORTENING.
DO NOT USE LARD.
Solid shortening will solidify in
the FILTER RESERVOIR and
FILTER PUMP. This condition
will render the filter system
inoperable. Do not attempt to
pump shortening unless it is
liquid shortening or shortening
melted to the liquid state.
Damage caused to attempts
to pump anything other than
shortening in the liquid state is
not covered under warranty.
12
IL2561
DRIP
TRAY
IL2562
IL2563
Advertisement
Table of Contents
