Chapter 6: Switch operations
This chapter describes some of the procedures that you perform to operate the Ethernet Routing Switch
8300 and provides troubleshooting information.
Navigation
•
Powering on DC power supplies
•
Powering on AC power supplies
•
Resetting the switch
•
Installing removable flash memory cards
•
Removing removable flash memory cards
•
Protecting memory card files
Powering on DC power supplies
Power on the DC power supplies to provide power to the switch.
Prerequisites
Ensure that the power supply is seated properly.
Procedure steps
1. On each DC power supply, turn On the power switch.
Installation — Chassis
on page 43
on page 46
Important:
When you first install a chassis that contains two or three power supplies, you
must turn on two of the power supply units simultaneously. If you wait longer to
turn on the second power supply, one of the power supplies could shut down. To
on page 41
on page 42
on page 44
on page 45
May 2011
41