York MILLENIUM YCAS Series Installation Operation & Maintenance page 127

S Y S # R U N
1 - 3 - 4 8 - 1 7
This message shows the Run Time logged on the sys-
tem since the last compressor start, in Days (D), Hours
(H), Minutes (M), and Seconds (S).
S Y S # M O T O R
This message indicates the compressor motor current
in as a percentage of Full Load Amps.
S Y S # O I L =
S T = 9 . 0 D T =
This message shows the system differential oil pressure
at the time of the fault.
S Y S # O I L =
S P = 6 2 D P =
This message indicates the system oil line temperature
at the time of the fault.
S # S A T S U C T
S U C T S H E A T
These messages indicate compressor suction gas satu-
ration temperature and superheat at the time of the fault.
S # S A T D S C H =
D S C H S H E A T
This message indicate compressor discharge gas satu-
ration temperature and superheat at the time of the fault.
YORK INTERNATIONAL
T I M E
D - H - M - S
C U R R E N T
7 8 % F L A
6 8 . 2 ° C
5 0 . 9 ° C
4 . 5 B A R G
1 8 . 7 B A R G
= 1 . 5 ° C
= 3 . 6 ° C
5 3 . 9 ° C
4 . 6 ° C
S Y S # S V S T E P
This message indicates the compressor slide valve po-
sition at the time of the fault. 0 steps equals minimum
capacity and 75 steps equals fully loaded.
S Y S # C O O L E R
R E F R I G T E M P
This message, which is only displayed if the unit is in
R-407c mode, indicates the refrigerant temperature at
the inlet of the cooler.
S Y S # L L S V
E C O N T X V S O L
This message indicates the Liquid Line Solenoid Valve
and the economizer Thermal Expansion Valve Solenoid
Valve position: ON = Energized / OFF = De-Energized
(OFF) at the time of the fault.
S Y S # F A N
C O M P H E A T E R
This message indicates the stage of condenser fan op-
eration on the system and the status of the compressor
heater at the time of the fault. See Section 8.4 for de-
tails of fan staging.
FORM 201.18-NM6
= 4 0
I N L E T
= - 2 . 1 ° C
I S O N
I S O F F
S T A G E 3
I S O F F
127
8