Fuji Xerox DocuPrint CM305 df Service Manual page 753

Motor/Clutch/Solenoid Name
(Diag. Code)
Fan Motor (HIGH/LOW)
Yellow Toner Motor / Magenta Toner
Motor / Cyan Toner Motor / Black
Toner Motor
1) Power on the printer, and enter the Diag Mode.
2) Execute the Fan Motor (HIGH or LOW).
3) Check that the Fan rotates.
4) Press the "STOP" key to stop the clutch.
NOTE: These procedures are for the technical staff.
Described below is the check procedure common among the four toner motor.
Note the operation for the toner in the PHD ASSY spills if the motor is rotated
for a long time.
1) Power on the printer, and enter the Diag Mode.
2) Open the Toner Access Cover and remove the toner cartridge.
3) Execute Yellow Toner Motor,Magenta Toner Motor,Cyan
Toner Motor or Black Toner Motor.
4) Check that the Gear rotates.
5) Press the "STOP" key to stop the clutch.
6) Replace the toner cartridge and close the Toner Access Cover.
6 – 107
Check procedure
Gear
Chapter 6 General
MiA02022GA
MiA02023GA