Fuji Xerox DocuPrint CM305 df Service Manual page 731

- CNG Stop Select
Sets the conditions for stopping CNG transmission. Below are the setting conditions:
CED&V21
CED
V21
- G3M TX Cable EQU
Sets the cable amplitude equalizer value for transmission. Below are the setting values:
0db
4db
8db
12db
- G3M RX Cable EQU
Sets the cable amplitude equalizer value for reception (applicable to V17, V29, and V27ter). Below
are the setting values:
0db
4db
8db
12db
- G3M V34 Bit Rate
Sets the signaling rate for the Super G3 (V34) mode.
The value can be set in the range of 2400bps to 33600bps in 14 steps. Below are the signaling
rates:
2400/4800/7200/9600/12000/14400/16800/19200/21600/24000/26400/28800/31200/33600
- Capability V34
Sets the communication capability of the Super G3 (V34) mode.
- G3M TX Coding
Sets the data encoding method for transmission. When the encoding method set here is not sup-
ported by the receiving side, the receiving side's method is adopted. Below are the encoding meth-
ods:
MH/MR/ MMR/JBIG
- G3M RX Cording
Sets the data encoding method for reception. Below are the encoding methods:
MH/MR/ MMR/JBIG
When CED and V.21 preamble are detected.
When CED is detected.
When V.21 preamble is detected.
Equivalent to a cable length of 0km.
Equivalent to a cable length of 1.9km.
Equivalent to a cable length of 3.6km.
Equivalent to a cable length of 7.2km.
Equivalent to a cable length of 0km.
Equivalent to a cable length of 1.9km.
Equivalent to a cable length of 3.6km.
Equivalent to a cable length of 7.2km.
6 – 85
Chapter 6 General