Fuji Xerox DocuPrint CM305 df Service Manual page 210

Step
Checking the paper guide sides setting and paper setting of
SSF.
9
Were the paper guide sides of SSF correctly set, and was
the paper correctly inserted into SSF?
Checking the paper condition.
10
Is the paper dry and recommended paper?
Checking noise when the paper is fed from the SSF.
11
Does the noise arise from the printer?
Checking the Duplex.
12 Does the noise arise when feeding the paper from the
Duplex?
Checking the FEEDER ASSY DUP AIO STD for installation.
13 Reseat the FEEDER ASSY DUP AIO STD.
Does the noise arise from the printer?
Checking the Duplex Motor (MOTOR ASSY DUP).
Does the noise arise from the printer?
14
Checked by [Digital Output] - [Duplex Motor] in [IOT Diag] of
diagnosis.
Checking the Main Motor.
Does the noise arise from the printer?
15
Checked by [Digital Output] - [Main Motor] in [IOT Diag] of
diagnosis.
Checking after resetting the PHD ASSY.
Reseat the PHD ASSY.
16 Does the noise arise from the printer?
Checked by [Digital Output] - [Main Motor] in [IOT Diag] of
diagnosis.
Checking after resetting the TRANSFER ASSY.
Reseat the TRANSFER ASSY.
17 Does the noise arise from the printer?
Checked by [Digital Output] - [Main Motor] in [IOT Diag] of
diagnosis.
Checking the foreign substances on the surfaces of the
ROLL ASSY REGI and ROLL REGI METAL.
18
Are there any foreign substances on the surfaces of these
parts?
Checking noise when printing.
19
Does the noise arise from the printer?
Checking the ROLL ASSY REGI and ROLL REGI METAL
for rotation.
Checked by [Digital Output] - [Main Motor] in [IOT Diag] and
20
then enter the [Digital Output] - [Regi Clutch] in [IOT Diag] of
diagnosis.
Does the noise arise from the Roller(s)?
Check
2 - 176
Chapter 2 Troubleshooting
Remedy
Yes
Reset the paper
guide sides, and
Go to step 10. correctly insert the
paper to SSF, then
go to step 10.
Replace the paper
with a new dry and
Go to step 12. recommended
one, then go to
step 11.
Go to step 12. End of work.
Go to step 13. Go to step 15.
Go to step 14. End of work.
Replace FEEDER
ASSY DUP SFP
End of work.
STD (Refer to
REP10.1.).
Go to step 16. Go to step 22.
Go to step 17. End of work.
Go to step 18. End of work.
Remove the
foreign
Go to step 20.
substances, then
go to step 19.
Go to step 20. End of work.
Replace the ROLL
ASSY REGI and/
Go to step 21.
or ROLL REGI
METAL.
No