Fuji Xerox DocuPrint CM305 df Service Manual page 266

Step
Checking the ROLL ASSY REGI and ROLL ASSY METAL
for rotation.
Checked by [Digital Output] - [Main Motor] in [IOT Diag],
and then enter the [Digital Output] - [Regi Clutch] in [IOT
11
Diag].
Does the Roll Assy Regi and Roll Regi Metal rotate?
During this check, cheat the interlock switch (HARN ASSY
INTERLOCK AIO).
Checking after resetting the Paper Cassette.
12 Reseat the Paper Cassette.
Is the image printed correctly?
Checking after resetting the paper.
13 Reseat the paper in the Paper Cassette.
Is the image printed correctly?
Checking the side guides of the Paper Cassette.
14 Reset the side guides.
Is the image printed correctly?
Checking the paper path.
15
Are there any foreign substances on the paper path?
16 Is the image printed correctly?
Checking after resetting the HOLDER ASSY SEPARATOR.
17 Reseat the HOLDER ASSY SEPARATOR.
Is the image printed correctly?
Checking after replacing the HOLDER ASSY SEPARATOR.
Replace the KIT HOLDER ASSY SEPARATOR. (Refer to
18
REP2.2.)
Is the image printed correctly?
Checking after resetting the ROLL ASSY FEED.
19 Reseat the ROLL ASSY FEED.
Is the image printed correctly?
Check
3 - 44
Chapter 3 Image Quality Troubleshooting
Remedy
Yes
End of work.
End of work.
End of work.
End of work.
Remove the
foreign
substances, then
go to step 16.
End of work.
End of work.
End of work.
End of work.
No
Replace the ROLL
ASSY REGI and/
or ROLL REGI
METAL.
Go to step 13.
Go to step 14.
Go to step 15.
Go to step 17.
Go to step 17.
Go to step 18.
Go to step 19.
Replace the KIT
ROLL ASSY
FEED. (Refer to
REP3.3.)