Fuji Xerox DocuPrint CM305 df Service Manual page 229

Step
Checking the paper.
6 Is the installed paper with a new and dry one? or does the
paper satisfy the specification?
Checking the TONER CARTRIDGE (Y, M, C or K) for
installation.
7 Shake and reseat the suspected TONER CARTRIDGE (Y,
M, C, or K).
Is the image printed correctly?
Checking the TONER CARTRIDGE (Y,M,C or K).
8 Is the toner cartridges installed to the printer the XEROX
toner?
Set the Non-XEROX toner option to [Off].
(Refer to [Non-XEROX Toner] in "21 Understanding the Tool
9
Box Menus".)
Is the image printed correctly?
Checking the PHD ASSY sealing ribbon.
After turning the printer off, open the front cover and remove
the PHD ASSY from the printer.Remove any of the 8 pieces
of sealing ribbon that may be left on the PHD ASSY.Then,
10
install the PHD ASSY into the printer.If the ribbon is found, it
takes a long time until the density is recovered. To use the
printer immediately, change the PHD ASSY to another one.
Is the image printed correctly?
Checking the TRANSFER ASSY for connection.
Open the COVER ASSY FRONT.
Are four HV terminals on the right side of the TRANSFER
ASSY, and four springs on the frame (PL4.1.11, 12, 13 and
14) dirty and/or deformed?
11
12 Is the image printed correctly?
Check
3 - 7
Chapter 3 Image Quality Troubleshooting
Remedy
Yes
Go to step 7.
End of work.
Go to step 10
End of work.
End of work.
Clean or replace
the TRANSFER
ASSY or
SPRING(s), then
go to step 12.
End of work.
No
Replace the paper
with a new and dry
one. or Change
the paper to the
one that satisfies
the specification.
Go to step 8
Go to step 9
Go to step 10
Go to step 11
Go to step 13.
Go to step 13.