Reinstall the Outer Cover
This procedure is best performed with the analyzer resting on its front
CAUTION
handles in the vertical position. Do not place the analyzer on its front panel
without the handles. This will damage the front panel assemblies.
1. Slide the cover onto the frame.
2. Using a T-20 TORX driver, install the four rear panel feet (item
④
screws (item
).
3. Slide the four bottom feet (item
4. Using a T-20 TORX driver, install the strap handles (item
②
(item
) on both ends.
Figure 20 Outer Cover Reinstallation
The figure above shows the N5230A front panel and floppy disk drive. The
NOTE
N5230C front panel has a slightly different appearance and does not
include a floppy disk drive.
32
⑤
) onto the cover.
③
) by installing the center
①
) by tightening the screws
Installation Note N5230-90010