Table of Contents
Advertisement
Step 5. Remove the Test Set Deck Front Panel
Refer to either
Figure 7
prefix of your analyzer.
1. Disconnect the wrapped wire cable (item
2. Using a T-10 TORX driver, remove eight screws (items
deck front panel, to release it.
3. Remove the test set deck front panel from the analyzer, with the LED board and both
couplers attached.
4. Remove the LED board from the front panel by removing the three attachment screws.
Retain the LED board and the screws for installation on the new front panel.
5. Using a 1-inch wrench, remove the flange nut (item
flange nuts for installation of the new couplers. Discard the front panel and the couplers.
Figure 7
Test Set Deck Front Panel Removal (serial numbers prefixed MY4500 and below)
Installation Note N5230-90010
or
Figure 8
for this procedure, depending upon the serial number
①
) from the front-panel LED board.
❶
through
②
) from each coupler. Retain the
❽
) from the test set
15
Advertisement
Table of Contents
