Table of Contents
Advertisement
Step 13. Reinstall the Front Panel Assembly
Before installing the front panel assembly onto the analyzer, place the analyzer
CAUTION
right side up and lift and support the front of the analyzer chassis.
Refer to
Figure 18
for this procedure.
1. Reconnect the ribbon cable (item
2. Slide the front panel over the test port connectors being careful to align the power switch
and floppy disk drive to their corresponding front panel cutouts. Ensure that the ribbon
②
cable (item
) is located below the fan to prevent it from being damaged by the fan blades.
3. With a T-10 TORX driver, install the eight screws (item
Figure 18 Front Panel Assembly Reinstallation
The figure above shows the N5230A front panel and floppy disk drive. The
NOTE
N5230C front panel has a slightly different appearance and does not
include a floppy disk drive.
30
②
) to the A3 front panel interface board.
①
) in the sides of the frame.
Installation Note N5230-90010
Advertisement
Table of Contents
