Installing The Secure Router 4134 Chassis In An Equipment Rack - Avaya Secure Router 4134 Installation Manual

Installing the Secure Router 4134 chassis in an equipment
rack
Install the Secure Router 4134 in a standard equipment rack (19 in.; 48.26cm).
Average time to install the Secure Router 4134 chassis in an equipment rack: 2 minutes.
Important:
You must install the Secure Router 4134 in a restricted-access location. You must limit
access to the Secure Router 4134 to authorized service personnel only.
Site location is important for the proper operation of the Secure Router 4134. Place the unit in
a clean, dry environment with adequate air circulation. Allow 2 to 3 feet (ft) (0.61 to 0.91 meters
[m]) of additional clearance around the Secure Router 4134 for access to the cable connectors
on the front and rear panels.
Important:
Avaya recommends that you install the chassis (which includes the power supplies and fan
tray) in the equipment rack before you install the ground lug and the optional external
interface modules.
Warning:
Risk of injury
The Secure Router 4134 weighs approximately 25 lb (11.34 kg) with one power supply and
the fan tray installed. To prevent injury, keep your back straight and lift with your legs, not
your back.
Caution:
Risk of equipment damage
Only trained personnel can install this product.
Caution:
Risk of equipment damage
To prevent damage from electrostatic discharge, always wear an antistatic wrist strap
connected to an ESD jack.
Prerequisites
• Confirm that your shipment is complete and undamaged.
• Ensure you have allotted adequate space in and around the equipment rack for
installation of the Secure Router 4134.
Installation — Chassis

Installing the Secure Router 4134 chassis in an equipment rack

August 2013 41