Power Supply Chassis; Power Supply Led; 8301Ac Power Supply - Avaya 8300 Installation Manual

AC power supply fundamentals

Power supply chassis

The Ethernet Routing Switch 8306 and 8310 chassis have three bays for power supplies. Use
the AC power supply for AC input power. You can install either the 8301AC or 8302AC power
supply in the 8306 or 8310 chassis. The Ethernet Routing Switch 8306 and 8310 chassis ship
with no installed power supplies. Power supply bays are numbered 1, 2, and 3, left to right, as
viewed from the front of the chassis.
The following table lists the number of 8301AC or 8302AC power supplies to install based on
the number of installed modules and the power supply redundancy choice.
Table 1: Recommended 8301AC or 8302AC power supplies
Chassis
8306
8310

Power supply LED

The following table describes the operation of the LED for the 8301 and 8302 power
supplies.
Table 2: Power supply LED for 8301AC and 8302AC
State
Off
On (green)

8301AC power supply

Figure 1: 8301AC power supply
power supply. The nominal input voltage range for the 8301AC power supply is 100–120 V AC
and 200–240 V AC. The output power is limited to 1140 W maximum at 100–120 V AC nominal
22 Installation — AC Power Supply
Number of
modules
1–6 1
1–6 1
7–10 2
Power supply not operational.
Power supply is ok.
on page 23 shows an Ethernet Routing Switch 8301AC
Number of power supplies
Required
2
2
3
Meaning
Redundant
configuration
May 2011