To insert the MMC:
1. Remove the two keypad screws and slide the keypad down and lift off (see
page
7-5).
2. Lift the MMC retaining door.
3. Position the MMC, with the contacts down, into the MMC holder. The MMC corner notch
fits into the holder only one way. Snap the retaining door closed.
Do not apply more than 4 in-lbs of torque when tightening the keypad screws.
4. Replace the keypad and re-attach using the two screws (see
MMC
MMC Retaining Door
Figure 7-3. Inserting the MMC
Accessories
Figure 7-1 on
Figure 7-2 on page
7-6).
7-7