Configuring The Thermostat Controller - Johnson Controls TEC3000 Series Installation Manual

20. Press Save.
Configuring the network settings for wireless models
1. Ensure the TEC screen is on.
2. Press the Menu icon.
Press Setup.
3.
Press Network Setup.
4.
5. Press FC Comm Mode and the Wireless Field Bus appears. This setting cannot be changed.
6. Press the back arrow to return to the previous screen.
Press BACnet Instance ID.
7.
8. Enter the BACnet
®
controllers on the site.
9. Press Save.
10. Press the back arrow to return to the previous screen.
11. Press BACnet Address.
12. Enter the BACnet address using the keypad. This value should be different to the other
controllers on the PAN.
13. Press Save.
14. Press the back arrow to return to the previous screen.
15. Press PAN ID.
16. Enter the PAN ID using the keypad. This value needs to be the same as set in the associated
ZFR Pro Coordinator Radio. Once the PAN is set, the TEC attempts to connect to the wireless
network. Provided that other devices on the PAN are in radio range, the connection should
occur within one minute. It can then take up to 10 minutes for the WNC gateway to display that
the device is online.
17. Press Save.

Configuring the thermostat controller

Use the Menu icon on the home screen to access and change the basic operating parameters of the
thermostat controller. During normal operation, press the Menu icon once to access the following
parameters:
• Fault Status
• Setpoints
• Schedule
• Display Settings
• Setup
• Trend
• Status
• Update
26 TEC3000 Series On/Off or Floating Fan Coil Thermostats Installation Guide
instance ID using the keypad. This value should be different to the other