Drilling, Counterboring - Cycle82 - Siemens Sinumerik 840D sl Programming Manual

Programming cycles externally
16.1 Technology cycles
16.1.3

Drilling, counterboring - CYCLE82

Programming
CYCLE82(REAL RTP, REAL RFP, REAL SDIS, REAL DP, REAL DPR, REAL DTB,
INT _GMODE, INT _DMODE, INT _AMODE)
Parameters
Param Param
No.
Mask intern
1
RP RTP
2
Z0 RFP
3
SC SDIS
4
Z1 DP
5
Z1 DPR
6
DT DTB
7
_GMODE
8
_DMODE
9
_AMODE
746
Explanation
Retraction plane (abs)
Reference point (abs)
Safety clearance (to be added to reference point, enter without sign)
Drilling depth (abs), see _AMODE
Drilling depth (inc), see _AMODE
Dwell time at final drilling depth, see _AMODE
Geometrical mode (evaluation of programmed geometrical data)
UNITS: Reserved
TENS: Drilling depth with respect to tip/shank
0 = Compatibility, tip
1 = Shank
Display mode
UNITS: Machining plane G17/G18/G19
0 = Compatibility, the level effective before cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
Alternative mode
UNITS: Drilling depth Z1 (abs/inc)
0 = Compatibility, from DP/DPR programming
1 = Incremental
2 = Absolute
TENS: Dwell time DT at final drilling depth in seconds/revolutions
0 = Compatibility, from DT sign (> 0 seconds / < 0 revolutions)
1 = in seconds
2 = in revolutions
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
Job planning