Siemens Sinumerik 840D sl Programming Manual page 778

Programming cycles externally
16.1 Technology cycles
Param Param
No.
Mask intern
30
_DMODE
31
_AMODE
Note
The cycle is provided with new functions that are not on earlier software versions.
Consequently certain parameters in the input mask (NUM, RAD, INDA) are no longer
displayed. Multiple slots on one position pattern can be programmed using "MCALL" and
calling the desired position pattern, e.g. HOLES2.
778
Explanation
Display mode
UNITS: Machining plane G17/18/19
0 = Compatibility, the levels effective before cycle call remain active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
TENS: Reserved
HUNDREDS: Reserved
THOUSANDS: Software version identification
1 = Functional extension SLOT1
Alternative mode
UNITS: Final depth Z1 (abs/inc)
0 = Compatibility
1 = Z1 (inc)
2 = Z1 (abs)
TENS: Reserved
HUNDREDS: Insertion depth for chamfering ZFS
0 = ZFS (abs)
1 = ZFS (inc)
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
Job planning