Path Traversing Behavior; Tangential Control (Tang, Tangon, Tangof, Tlift, Tangdel) - Siemens Sinumerik 840D sl Programming Manual

Path traversing behavior

8.1

Tangential control (TANG, TANGON, TANGOF, TLIFT, TANGDEL)

Function
The following axis follows the path of the leading axis along the tangent. This allows
alignment of the tool parallel to the contour. Using the angle programmed in the
TANGONinstruction, the tool can be positioned relative to the tangent.
Job planning
Programming Manual 02/2011, 6FC5398-2BP40-1BA0
8
463