Siemens Sinumerik 840D sl Programming Manual page 799

No. Param Mask Param intern
11
_VARI
12
R1/FS1 _RF1
13
R2/FS2 _RF2
14
R3/FS3 _RF3
15
SC _SDIS
16
F _FF1
17
_NR
18
_DMODE
Job planning
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
Explanation
Machining type
UNITS: Stock removal direction (longitudinal or transverse) in the coordinate system
1 = Longitudinal
2 = Transverse
TENS:
1 = Roughing to finishing allowance
2 = Finishing
HUNDREDS:
0 = With rounding at the contour, without residual corners
1 = Without rounding at the contour
THOUSANDS:
0 = With radius/chamfer at corner 2
1 = With undercut at corner 2
TEN THOUSANDS:
0 = Stand still after machining
1 = Return to starting position
Rounding radius or chamfer width 1, see _AMODE (TEN THOUSANDS)
Rounding radius or chamfer width 2, see _AMODE (HUNDRED THOUSANDS)
Rounding radius or chamfer width 3, see _AMODE (ONE MILLION)
Safety clearance
Feedrate for roughing/finishing
Identification of stock removal type (corresponds to vertical softkey for selecting
form):
0 = Stock removal 1, 90 degree corner without chamfers/rounding
1 = Stock removal 2, 90 degree corner with chamfers/rounding
2 = Stock removal 3, any corner with chamfers/rounding
Display mode
UNITS: Machining plane G17/G18/G19
0 = Compatibility, the level effective before cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
TENS: Form of input _ZPD/_ZPL
0 = Xm/Zm
1 = Xm/α1
2 = Xm/α2
3 = α1/Zm
4 = α2/Zm
5 = α1/α2
Programming cycles externally
16.1 Technology cycles
799