Deselect Transformation (Trafoof) - Siemens Sinumerik 840D sl Programming Manual

Transformations

6.11 Deselect transformation (TRAFOOF)

6.11 Deselect transformation (TRAFOOF)
Function
The TRAFOOF command deactivates all active transformations and frames.
Note
Frames required after this must be activated by renewed programming.
Please note:
The same restrictions as for selection are applicable to deselecting the transformation (see
section "Constraints when selecting a transformation").
Syntax
TRAFOOF
Significance
TRAFOOF
398
Command for deactivating all active transformations/frames
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
Job planning