Control Panel - Supero SUPERSERVER 6014P-T User Manual

S S
UPER ERVER 6014P-T/6014P-TR User's Manual
Figure 6-1. Chassis: Front and Rear Views
Slim DVD-ROM Drive
6014P-T
GLAN Ports
USB0/1 Ports Mouse/Keyboard Ports
6014P-TR
GLAN Ports
USB0/1 Ports Mouse/Keyboard Ports
6-2

Control Panel

The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the appropriate header on the Control
Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both
connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System
Interface" for details on the LEDs and the control panel buttons. Details on JF1
can be found in "Chapter 5: Advanced Serverboard Setup."
Slim Floppy Drive
SATA Drives
PCI Expansion Slots
VGA Port
PCI Expansion Slot COM Port
6-2
UID Button and LED
System LEDs
COM Port
Power Supply
UID Button/LED
Power Supplies
VGA Port UID Button/LED
Control Panel
Main Power