Table of Contents
Advertisement
Chapter 2: Server Installation
Installing the Server into a Telco Rack
To install the 6014P-T/6014P-TR into a Telco type rack, use two L-shaped brackets
on either side of the chassis (four total). First, determine how far the server will
extend out the front of the rack. Larger chassis should be positioned to balance
the weight between front and back. If a bezel is included on your server, remove
it. Then attach the two front brackets to each side of the chassis, then the two rear
brackets positioned with just enough space to accommodate the width of the rack.
Finish by sliding the chassis into the rack and tightening the brackets to the rack.
Figure 2-4. Installing the Server into a Telco Rack
2-7
Advertisement
Table of Contents
