Table of Contents
Advertisement
6014P-T
The SuperServer 6014P-T has a single 560 watt cold-swap power supply, which is
auto-switching capable. This enables it to automatically sense and operate with a
100v - 240v input voltage. An amber light will be illuminated on the power supply
when the power is off. An illuminated green light indicates that the power supply
is operating.
Power Supply Failure
If the power supply module fails, the system will shut down and you will need to
replace the module. Replacements can be ordered directly from Supermicro (see
contact information in the Preface). As there is only one power supply module in
the 6014P-T, power must be completely removed from the server before removing
and replacing the power supply for whatever reason.
Removing/Replacing the Power Supply
1.
Removing the power supply
First turn the power switch on the control panel off, then unplug the power cord
from the system. To remove the failed power module, fi rst locate the colored re-
lease tab (1). Push the tab to the right (2) and then pull the module straight out
with the handle provided (3) (Figure 6-5). The power supply wiring was designed
to detach automatically when the module is pulled from the chassis.
2.
Installing a new power supply
Replace the failed power supply with another SP562-1R power supply module
(p/n PWS-0057). Carefully insert the new power supply into the open bay and
push it completely into the chassis until you hear a clicking sound, meaning it has
been fully inserted. Finish by reconnecting the AC power cord and depressing
the power button on the chassis front control panel.
Chapter 6: Advanced Chassis Setup
6-9
Advertisement
Table of Contents
