Supero SUPERSERVER 6014P-T User Manual page 87

Serial Port B
This setting allows you to assign control of serial port B. The options are Enabled
(user defi ned), Disabled, Auto (BIOS controlled) and OS Controlled.
Mode
Specify the type of device that will be connected to serial port B. The options
are Normal, and IR (for an infrared device).
Base I/O Address
Select the base I/O address for serial port B. The options are 3F8, 2F8,
3E8 and 2E8.
Parallel Port
This setting allows you to assign control of the parallel port. The options are
Enabled (user defi ned), Disabled and Auto (BIOS-or OS- controlled).
Base I/O Address
Select the base I/O address for the parallel port. The options are 378, 278
and 3BC.
Interrupt
Select the IRQ (interrupt request) for the parallel port. The options are IRQ5
and IRQ7.
Mode
This feature allows you to specify the parallel port mode. The options are
Output only, Bi-Directional, EPP and ECP.
PCI-E Express Jitter Tolerance
This feature allows the user to set the PCI-E Jitter Tolerance Level.
options are: 4 to 12.
PCI-E Port A Device 2/PCI-E Port B Device 4
If enabled, the feature allows you to set the device selected to be compliant
with the PCI-Express Compliance 1.0 Mode.
Enabled and Auto.
The options are: Disabled,
7-15
Chapter 7: BIOS
The