Processor And Heatsink Installation - Supero SUPERSERVER 6014P-T User Manual

S S
UPER ERVER 6014P-T/6014P-TR User's Manual
5-2

Processor and Heatsink Installation

When handling the processor package, avoid placing direct pressure
on the label area of the fan. Also, do not place the motherboard on a
!
conductive surface, which can damage the BIOS battery and prevent
the system from booting up.
IMPORTANT: Always connect the power cord last and always remove it before add-
ing, removing or changing any hardware components. Make sure that you install
the processor into the CPU socket before you install the CPU heat sink.
CPU Installation
1. Lift the lever on the CPU socket: Lift
the lever completely as shown on the
picture on the right; otherwise, you will
damage the CPU socket when power is
applied. Install CPU1 fi rst.
2. Insert the CPU in the socket,
making sure that pin 1 of the CPU
aligns with pin 1 of the socket (both
corners are marked with a triangle).
When using only one CPU, install it
into CPU socket #1. (Socket #2 is
automatically disabled if only one
CPU is used.)
3. Press the lever down until you
hear a *click*, which means the
CPU is securely installed in the
CPU socket. Repeat these steps if
you wish to install a second CPU in
socket#2.
Socket lever in the
locked position
5-2
Socket lever
Pin 1