Table of Contents
Advertisement
About This Manual
This manual is written for professional system integrators and PC technicians.
It provides information for the installation and use of the SuperServer 6014P-
T/6014P-TR. Installation and maintainance should be performed by experienced
technicians only.
The SuperServer 6014P-T/6014P-TR is a high-end server based on the SC814+T-
560/SC814+T-R560 1U rackmount chassis and the Super X6DHP-TG, a dual
processor serverboard that supports Intel
Side (System) Bus speed of 800 MHz and up to 12/24 GB of registered ECC
DDR333/266 SDRAM.
Manual Organization
Chapter 1: Introduction
The fi rst chapter provides a checklist of the main components included with the
server system and describes the main features of the X6DHP-TG serverboard
and the SC814+T-560/SC814+T-R560 chassis, which comprise the SuperServer
6014P-T/6014P-TR.
Chapter 2: Server Installation
This chapter describes the steps necessary to install the SuperServer 6014P-
T/6014P-TR into a rack and check out the server confi guration prior to powering
up the system. If your server was ordered without processor and memory com-
ponents, this chapter will refer you to the appropriate sections of the manual for
their installation.
Chapter 3: System Interface
Refer here for details on the system interface, which includes the functions and
information provided by the control panel on the chassis as well as other LEDs
located throughout the system.
Preface
®
64-bit Xeon
iii
Preface
TM
processors at a Front
Advertisement
Table of Contents
