Power Supply - Supero SUPERSERVER 6014P-T User Manual

S S
UPER ERVER 6014P-T/6014P-TR User's Manual
6-5

Power Supply

6014P-TR
The SuperServer 6014P-TR has a redundant 560 watt power supply confi guration
consisting of two hot-swappable power modules. The power supply modules have
an auto-switching capability, which enables them to automatically sense and operate
with a 100V - 240V input voltage.
Power Supply Failure
If either of the two power supply modules fail, the other module will take the full
load and allow the system to continue operation without interruption. The Power
On LED on the control panel will turn yellow and remain on until the failed module
has been replaced. Replacement modules can be ordered directly from Supermicro
(see contact information in the Preface). The power supply modules have a hot-
swap capability, meaning you can replace the failed module without powering down
the system.
Removing/Replacing the Power Supply
You do not need to shut down the system to replace a power supply module.
The redundant feature will keep the system up and running while you replace the
failed hot-swap module. Replace with the same model - SP562-1R (p/n PWS-
0057), which can be ordered directly from Supermicro (see Contact Information in
the Preface).
1. Removing the power supply
First unplug the power cord from the failed power supply module. To remove
the failed power module, fi rst locate the colored release tab (1). Push the tab to
the right (2) and then pull the module straight out with the handle provided (3)
(Figure 6-5, single power supply server shown). The power supply wiring was
designed to detach automatically when the module is pulled from the chassis.
2. Installing a new power supply
Replace the failed hot-swap module with another SP562-1R power supply mod-
ule. Simply push the new power supply module into the power bay until you hear
a click. Finish by plugging the AC power cord back into the module.
6-8