Serverboard Features - Supero SUPERSERVER 6014P-T User Manual

S S
UPER ERVER 6014P-T/6014P-TR User's Manual
SuperServer 6014P-T/6014P-TR User's Manual
1-2

Serverboard Features

At the heart of the SuperServer 6014P-T/6014P-TR lies the X6DHP-TG, a dual
processor serverboard based on Intel's E7520 chipset. Below are the main features
of the X6DHP-TG (see Figure 1-1 for a block diagram of the chipset).
Processors
The X6DHP-TG supports single or dual 604-pin Intel Xeon EM64T type processors
at a FSB speed of 800 MHz. Please refer to the serverboard description pages on
our web site for a complete listing of supported processors.
Memory
The X6DHP-TG has six 184-pin DIMM sockets that can support up to 12 GB of
registered ECC DDR333 (PC2700) or up to 24 GB of registered ECC DDR266
(PC2100) SDRAM. The memory is an interleaved confi guration, which requires
modules of the same size and speed to be installed in pairs. Please refer to Chapter
5 for memory speed jumper settings.
Serial ATA
A Marvell SATA controller is integrated into the X6DHP-TG to provide a four-port
Serial ATA subsystem, which is RAID 0 and 1 supported. The ICH5R South Bridge
of the chipset also includes a Serial ATA controller that supports two SATA ports
(RAID 0, 1 and JBOD supported). The SATA drives are hot-swappable units.
Notes: The operating system you use must have RAID support to enable the
hot-swap capability and RAID function of the Serial ATA drives. The system sup-
ports Zero Channel RAID (ZCR) with an Adaptec 2020SA card (not included) in
the JPCIX1 slot (RAID levels 0, 1, 5 and 10 supported).
Onboard Controllers/Ports
One fl oppy drive controller and two onboard ATA/100 controllers are provided to
support up to four IDE hard drives or ATAPI devices. The color-coded I/O ports
include one COM port*, a VGA (monitor) port, two USB 2.0 ports, PS/2 mouse and
keyboard ports and two gigabit Ethernet ports.
*The backpanel COM port is available with the use of the rear COM port kit (included
with system). COM1 and COM2 are both headers on the X6DHP-TG.
1-2