Jlan Enable/Disable; Sata Enable/Disable; Bios Debug - Supero SUPERSERVER 6014P-T User Manual

JLAN Enable/Disable

Change the setting of jumper JPL1 to
enable or disable the onboard LAN
ports (JLAN1 and JLAN2) on the
serverboard. See the table on the
right for jumper settings. The default
setting is enabled

SATA Enable/Disable

Close pins 1 and 2 of JPS1 to enable
the Marvell SATA controller. See the
table on the right for jumper settings.
The default setting is enabled.

BIOS Debug

Close pins 2 and 3 of J27 to allow
the system to search for the rescue
disk from the fl oppy drive to refresh
the BIOS when the BIOS crashes.
See the table on the right for jumper
settings. The default setting is pins 1
and 2 closed (normal).
Chapter 5: Advanced Serverboard Setup
JLAN Enable/Disable
Jumper Settings (JPL1)
Jumper Setting
Pins 1-2
Pins 2-3
SATA Enable/Disable
Jumper Settings (JPS1)
Jumper Setting
Pins 1-2
Pins 2-3
5-19
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled