Fig. 16: Aligning machine head (6)
⑧
(8) - Screw on the right
7. Loosen the screws on the left (not shown) and on the right (8).
8. Use the threaded pins on the left (not shown) and on the right (9) to
9. Test the height of the base plate using flat material (3) and adjust as
10. Check heights X and adjust as necessary.
11. Check locking mechanism and adjust as necessary.
27
adjust the height of the machine head at the rear:
• higher = turn clockwise
• lower = turn counterclockwise
necessary.
(9) - Threaded pin on the right
Service Instructions 911-211 - 02.0 - 10/2016
Working basis
⑨